RF ToolBox

Developer: Black Cat Systems

Current Version: 4.0.0

Last Updated: 4 years ago

Download Size: 5.5 MB - Download


RF Toolbox is an antenna design and electronics/electrical tool package. It takes you step by step through the design of the following types of antennas:
Fat Dipole
Long Yagi
Super J-Pole
Log Periodic
Cubic Quad

It also performs the following calculations:

Transmission Line Calculator
Coil Design
LC Filter Design
Transmission Line Loss
L Matching Networks
Pi Matching Networks
Impedance Calculations
Wire Gauge and Resistance and Voltage Drop
Wire Inductance Calculations
dB Calculations
Resistor Series/Parallel Calculations
Resistor Color Code Calculations
Low and High Pass Butterworth and Chebyshev Filter Design
Thermal Noise Calculator
Pi Network Attenuator Calculator
Tee Network Attenuator Calculator
555 Timer Oscillator Calculator
RF Link Budget Calculator
Gamma Match Calculator
Skin Depth Calculator

With the transmission line calculator, you can select the type of line, length, operating frequency, and calculate the losses, as well as the SWR and losses from SWR due to impedance mismatch. The load impedance can also be calculated from the measured impedance at the line input.


More Reviews for Current Version

Version 4.0.0
Review by Kale-C

I can’t open the program - I just purchased this from the apple app store and I get the icon in my launch pad but it won’t open, So far I have been unable to find a source of help from “Black Cat Systems” or Apple. I had a glitch some where after forcing the program to quit and restarting all works well.. so far. I think all is OK!

Found helpful by 2 out of 2 people
Version 4.0.0
Review by Pirate-T

Cannot Open - Was able to open the program a few times, now cannot open. I wold give it a higher rateing if I could use it.

Found helpful by 0 out of 0 people
Version 4.0.0
Review by Popawdo

What’s not to like? It works if you go to the top of the page! - Good question. Since downloading, I have NOT been able to see anything but the Apple tool bar at the top of the page. I will survive. The program, however, is doomed unless it is made serviceable. 73. Re-installed twice…still only get the bar at the top but no content. This does not work on my Mac HOLD ON!!! I JUST TRIED SOMETHING REVOLUTIONARY! I FOLLOWED THE INSTRUCTIONS!. I STARTED THE PROGRAM, WENT TO THE VERY TOP OF THE PAGE AND, EUREKA!, A TOOL MENUE IN WHICH I CLICKED “DIPOLE” AND THIS PROGRAM IS EXACTLY WHAT IT SAYS IT IS.

Found helpful by 0 out of 0 people